This document explains how to update the Firmware, operating system, and software packages for the sbRIO-9651 installed on the PED-Board. Remember that LabVIEW 2025 Q3 must be installed.
To begin, open NI-MAX and select the PED-Board you want to configure. Then, click Update Firmware
Select the following file
After selecting the file, click Begin Update
Log in as ‘admin’ without anypassword
The update will now start
Wait until it is installed.
Now, select Add/Remove Software by right clicking the tab ‘Software’ under the desired PED-Board
Select the option Linux RT System Image 2025 Q3 and click OK.
Wait for the preparation
Select LabVIEW 2025 and click Next
The window shown below will show up. Select the 16 packages summarized in the next image and press Review Changes
Use this image to select the software in the previous step. Now, double-check the 16 packages and click Continue
Wait for the installation until it is done.
